D2 CAD Make Part3

Explanation of this document is applied to the newest version.

Three processes which make parts
1) Parts element
2) Parts-izing
3) Parts-ized dialog

Parts-ized dialog

If the item which constitutes parts is chosen and the button of parts-izing is pushed, the dialog of the next figure will come out.

Parts name
(Name) The name of parts is inputted.
Although distinguished from the name registered into a library, it is made as same the name as possible.

Reference sign
(Ref) A parts number is just going to be inputted.
A parts number goes into the position of "?." "?" is surely required.
When there are sub numbers, such as TTL, It registers individually like U?A and U?B.

Initial value
(Value) The initial value of parts is inputted.
Probably, it is good to input the value often used.
Of course, it can change by edit of parts.

An element number and an element total It is used when two or more parts are in one packages, such as TTL.
When there is nothing, it is O.K. with this.

Logic reversal It is used to input the form of logic reversal, such as TTL.

Power-supply pin un-displaying. When parts are inputted, it chooses whether a power-supply pin is displayed.
Of course, it can change per pin by parts edit later.

The starting point is decided. If O.K. button is pushed, a dialog will close. And it moves so that a mouse cursor may specify the position of the parts starting point.
Usually, an upper left pin is specified. Please push the left button of a mouse after moving to change the starting point of parts.
The starting point of parts is the parameter used in the case of a parts input.
Please be sure to specify a main grid.

The operation method, a request, a question, etc.

fwgf3995@mb.infoweb.ne.jp It passes.

This page is translated with translation software from Japanese.
Go Top

	Parts name (Name)	The name of parts is inputted. Although distinguished from the name registered into a library, it is made as same the name as possible.
	Reference sign (Ref)	A parts number is just going to be inputted. A parts number goes into the position of "?." "?" is surely required. When there are sub numbers, such as TTL, It registers individually like U?A and U?B.
	Initial value (Value)	The initial value of parts is inputted. Probably, it is good to input the value often used. Of course, it can change by edit of parts.
	An element number and an element total	It is used when two or more parts are in one packages, such as TTL. When there is nothing, it is O.K. with this.
	Logic reversal	It is used to input the form of logic reversal, such as TTL.
	Power-supply pin un-displaying.	When parts are inputted, it chooses whether a power-supply pin is displayed. Of course, it can change per pin by parts edit later.
	The starting point is decided.	If O.K. button is pushed, a dialog will close. And it moves so that a mouse cursor may specify the position of the parts starting point. Usually, an upper left pin is specified. Please push the left button of a mouse after moving to change the starting point of parts. The starting point of parts is the parameter used in the case of a parts input. Please be sure to specify a main grid.