ar7240> setenv ipaddr 10.10.10.190
ar7240> setenv serverip 10.10.10.3
ar7240> tftpboot 0x80800000 Buffalo_WHR-HP-G300N_kernel.kbin.oldlzma.uboot
Using eth1 device
TFTP from server 10.10.10.3; our IP address is 10.10.10.190
Filename 'Buffalo_WHR-HP-G300N_kernel.kbin.oldlzma.uboot'.
Load address: 0x80800000
Loading: #################################################################
         #################################################################
         #################################################################
         ###########################
done
Bytes transferred = 1131603 (114453 hex)
ar7240> bootm 0x80800000
## Booting image at 80800000 ...
   Image Name:   FreeBSD Kernel Image
   Created:      2015-07-12  11:34:59 UTC
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    1131539 Bytes =  1.1 MB
   Load Address: 80001000
   Entry Point:  80001000
   Verifying Checksum ... OK
   Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80001000) ...
## Giving linux memsize in bytes, 33554432

Starting kernel ...

CPU platform: Atheros AR7240 rev 2
CPU Frequency=400 MHz
CPU DDR Frequency=400 MHz
CPU AHB Frequency=200 MHz
platform frequency: 400000000
arguments: 
  a0 = 00000007
  a1 = a1f71fb0
  a2 = a1f72460
  a3 = 00000008
Cmd line: (null) console=ttyS0,115200 root=31:03 rootfstype=jffs2 init=/sbin/ini
t mtdparts=ar7240-nor0:248k(u-boot),8k(u-boot-env),896k(uImage),2816k(rootfs),64
k(NVRAM),64k(ART) mem=32M
Environment:
envp skiped
Cache info:
  picache_stride    = 4096
  picache_loopcount = 16
  pdcache_stride    = 4096
  pdcache_loopcount = 8
cpu0: MIPS Technologies processor v116.147
  MMU: Standard TLB, 16 entries
  L1 i-cache: 4 ways of 512 sets, 32 bytes per line
  L1 d-cache: 4 ways of 256 sets, 32 bytes per line
  Config1=0x9ee3519e<PerfCount,WatchRegs,MIPS16,EJTAG>
  Config3=0x20
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2012 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 10.0-CURRENT #0: Sun Jul 12 20:34:37 JST 2015
    hiroki@microserver:/usr/home/hiroki/ZRouter/obj/usr/home/hiroki/ZRouter/zrou
ter/tmp/mips.mips/usr/home/hiroki/ZRouter/FreeBSD/head/sys/usr/home/hiroki/ZRout
er/obj/usr/home/hiroki/ZRouter/zrouter/conf/Buffalo_WHR-HP-G300N mips
real memory  = 33554432 (32768K bytes)
avail memory = 27226112 (25MB)
random device not loaded; using insecure entropy
nexus0: <MIPS32 root nexus>
clock0: <Generic MIPS32 ticker> on nexus0
Timecounter "MIPS32" frequency 200000000 Hz quality 800
Event timer "MIPS32" frequency 200000000 Hz quality 800
apb0 at irq 4 on nexus0
uart0: <16550 or compatible> on apb0
uart0: console (115200,n,8,1)
gpio0: <Atheros AR71XX GPIO driver> on apb0
gpio0: [GIANT-LOCKED]
gpio0: gpio pinmask=0x3ffff
gpiobus0: <GPIO bus> on gpio0
gpiobus0: GPIO device with 18 pins
gpioled0: Use pinmask=0x00000001
gpioled1: Use pinmask=0x00000002
gpioled2: Use pinmask=0x00000800
gpiobutton0: Use pinmask=0x00001000
gpioc0: <GPIO controller> at pin(s) 0-17 on gpiobus0
gpioled0: <GPIO led> at pin(s) 0 on gpiobus0
gpioled0: /dev/led/wps flags=0102
gpioled1: <GPIO led> at pin(s) 1 on gpiobus0
gpioled1: /dev/led/status flags=0102
gpioled2: <GPIO led> at pin(s) 11 on gpiobus0
gpioled2: /dev/led/usb flags=0102
pcib0 at irq 0 on nexus0
pci0: <PCI bus> on pcib0
pci0: <network, ethernet> at device 0.0 (no driver attached)
arge0: <Atheros AR71xx built-in ethernet interface> at mem 0x19000000-0x19000fff
 irq 2 on nexus0
arge0: Overriding MAC from EEPROM
miibus0: <MII bus> on arge0
floatphy0 PHY 0 on miibus0
floatphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseSX, 1000base
SX-FDX, 1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-FDX-master, auto
switch0 PHY 1 on miibus0
ar8x16_switch0: <AR8216.2 Ethernet switch> on switch0
arge0: Ethernet address: ff:ff:ff:ff:ff:ff
arge1: <Atheros AR71xx built-in ethernet interface> at mem 0x1a000000-0x1a000fff
 irq 3 on nexus0
miibus1: <MII bus> on arge1
floatphy1 PHY 0 on miibus1
floatphy1:  1000baseSX, 1000baseSX-FDX, 1000baseT, 1000baseT-master, 1000baseT-F
DX, 1000baseT-FDX-master, auto
arge1: Ethernet address: ff:ff:ff:ff:ff:00
spi0: <AR71XX SPI> at mem 0x1f000000-0x1fffffff on nexus0
spibus0: <spibus bus> on spi0
mx25l0: <M25Pxx Flash Family> at cs 0 mode 0 on spibus0
mx25l0: mx25ll32, sector 65536 bytes, 64 sectors
ar71xx_wdog0: <Atheros AR71XX watchdog timer> on nexus0
Timecounters tick every 10.000 msec
Trying to mount root from cd9660:/dev/map/rootfs.uncompress []...
mountroot: waiting for device /dev/map/rootfs.uncompress ...
Mounting from cd9660:/dev/map/rootfs.uncompress failed with error 19.

Loader variables:

Manual root filesystem specification:
  <fstype>:<device> [options]
      Mount <device> using filesystem <fstype>
      and with the specified (optional) option list.

    eg. ufs:/dev/da0s1a
        zfs:tank
        cd9660:/dev/acd0 ro
          (which is equivalent to: mount -t cd9660 -o ro /dev/acd0 /)

  ?               List valid disk boot devices
  .               Yield 1 second (for background tasks)
  <empty line>    Abort manual input

mountroot>