-Line Drawing Character setting

             OPT LINECH [on | off | filename | reload ]

#if defined(LNX) || !defined(XXE)
            on/off  :Selection of output string xxxx of yyyy of ini file.(See LineDrawingChar)
                      if both specified by the ini file(xelch__.ini[.locale]).
                      select output string xxxx(ON) or yyyy(OFF).
                      (on other than linux console version,xxxx or yyyy
                      selection is done by +Shiftkey. linux console
                      version cannot detect complex +Shift key combination)
                      default is off.
                      And if ON and xxxx is 1 byte character,that byte is
                      displayed as Line-Drawing-Character.(use ACS function)

                      Set off if your language use codepoint >0xa0 e.g. ISO8859-1.
#endif
             filename:temporarily setup from this file.
           reload  :re-read the default file.

           you can see the result of ini file process on =0.2 panel.